Double Pulses

The normally desired mode of operation of a Q-switched laser leads to the generation of a single pulse (typically with a nanosecond duration) per Q-switching cycle. Under certain circumstances, however, multiple pulses may be emitted within a single Q-switching cycle. Typical reasons for such behavior are:

• If the switching time of the modulator is too long, the first pulse may not be able to extract fully the energy stored in the gain medium. A second pulse may then be generated at a later time, where the modulator has reached the state of lowest loss.
• If the laser is continuously pumped and the opening time of the modulator is too long, sufficient energy may be accumulated in the gain medium to form a second pulse.

For predicting or analyzing such effects, it can be very helpful to simulate the laser dynamics numerically.

With mode locking of a laser, one usually obtains a single ultrashort pulse circulating in the laser resonator, or (with harmonic mode locking) multiple pulses with equidistant spacing. In some situations, however, a circulating pulse may break up into two or more closely spaced pulses, leading to multiple pulses in the output pulse train. This occurs particularly often in passively mode-locked lasers operating in the femtosecond domain, e.g. with soliton mode locking.

Multiple pulses can sometimes form a relatively stable configuration, since there can be various physical effects which permit some kind of interaction between the pulses. These pulses can then do many resonator round trips with constant spacing and even constant phase, i.e., they remain mutually coherent. As a result of that, the optical spectrum is strongly modulated (see also a Spotlight article). In fact, such a spectrum often leads to the discovery of that phenomenon.

In other cases, however, multiple pulses can be very unstable, at least concerning their relative phase. A modulated spectrum then cannot be observed.

Detection of double pulsing of mode-locked lasers is possible, e.g. with the following methods:

• It can often be seen as a modulation of the optical spectrum, recorded with an optical spectrum analyzer (see above). This method may fail, however, when the relative phase is not sufficiently stable, or when the spectral resolution is insufficient (for large pulse spacings).
• A more direct way is to use a fast photodiode and a sampling oscilloscope. Correct triggering may require special care and is challenging particularly in unstable situations. Only for pulse spacings of 100 ps or larger is the measurement bandwidth of a fast photodiode sufficient for detecting double pulses.
• For small enough pulse spacing, double pulsing may also be detected with an autocorrelator.
• A sign of double or multiple pulsing can be that the conversion efficiency of a frequency doubler is lower than that theoretically expected or it fluctuates without apparent reason. This results from the reduced peak power, when a certain total energy (as obtained from the measured average laser power) is spread over several pulses, or from fluctuations of peak power in situations with unstable pulse numbers.

Your question or comment:

Spam check:

  (Please enter the sum of thirteen and three in the form of digits!)

By submitting the information, you give your consent to the potential publication of your inputs on our website according to our rules. (If you later retract your consent, we will delete those inputs.) As your inputs are first reviewed by the author, they may be published with some delay.