Fiber Lasers Which Are No Fiber Lasers
Posted on 2008-06-06 as a part of the Photonics Spotlight (available as e-mail newsletter!)
Permanent link: https://www.rp-photonics.com/spotlight_2008_06_06.html
Author: Dr. Rüdiger Paschotta, RP Photonics Consulting GmbH
Abstract: Fiber laser products often strictly do not contain a fiber laser, but rather a master oscillator fiber amplifier. This may or may not be relevant for the customer. The high sensitivity of such devices to optical feedback can be a problem of which many people are no aware.
Ref.: encyclopedia articles on fiber lasers, master oscillator fiber amplifier, fiber lasers versus bulk lasers
There are quite a few laser products which are marketed as fiber lasers, even though they are strictly no fiber lasers. In reality, they contain some kind of laser – which may or may not be a fiber laser – and a fiber amplifier for boosting the output power. In case of high power fiber laser products, you almost always actually obtain a so-called master oscillator fiber amplifier setup.
An imprecise statement on a product is not necessarily one for which the manufacturer should be criticized. In the discussed kind of case, the product often exhibits some typical properties of fiber lasers: a high beam quality combined with high output power, a compact setup, a high wall-plug efficiency, an undefined polarization state of the output (although there are also polarization-maintaining fiber devices), and a larger emission bandwidth (which may be irrelevant for the customer).
There is one more property, though, which the customer may not be aware of: the very much higher sensitivity to any optical feedback. A high-gain amplifier will also strongly amplify any light coming back e.g. from a workpiece, and send it toward the seed laser. The effect may not only be some malfunction, but easily a serious damage. This problem may be cured by including a Faraday isolator (or even two of those, to obtain a sufficient degree of isolation), but this is often not practical, as a bulky and expensive component would have to be added to the setup. The customer may then be unhappy to find only in the small print that any reflections going back into the device must be carefully avoided.
With the advent of fiber laser products, which are technically fairly variable, one rule has become significantly more important: don't buy a laser device before you sufficiently well understand its properties – either with in-house knowledge, or by getting help from an external consultant, who is independent of the manufacturers.
This article is a posting of the Photonics Spotlight, authored by Dr. Rüdiger Paschotta. You may link to this page and cite it, because its location is permanent. See also the RP Photonics Encyclopedia.
Note that you can also receive the articles in the form of a newsletter or with an RSS feed.
Questions and Comments from Users
Here you can submit questions and comments. As far as they get accepted by the author, they will appear above this paragraph together with the author’s answer. The author will decide on acceptance based on certain criteria. Essentially, the issue must be of sufficiently broad interest.
Please do not enter personal data here; we would otherwise delete it soon. (See also our privacy declaration.) If you wish to receive personal feedback or consultancy from the author, please contact him e.g. via e-mail.
By submitting the information, you give your consent to the potential publication of your inputs on our website according to our rules. (If you later retract your consent, we will delete those inputs.) As your inputs are first reviewed by the author, they may be published with some delay.
 |
If you like this page, please share the link with your friends and colleagues, e.g. via social media:
These sharing buttons are implemented in a privacy-friendly way!